LAN Configuration and Management Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series

121

122

123

124

125

126

127

128

129

130

SCF Commands for the SLSA Subsystem

LAN Configuration and Management Manual—520469-012

4-62

INFO SAC Command

AutoFirmup

indicates whether the firmware revision file and the firmware currently in the SAC

are compared during the startup sequence. The firmware revision file and the

current firmware are always compared but not automatically updated. ON indicates

that the firmware file is downloaded to the adapter if the firmware file is a newer

revision than that currently running in the adapter. The default is ON. The

AUTOFIRMUP option does not apply to MFIOB adapters.

AutoReload

indicates whether application microcode is downloaded automatically to the SAC if

it fails. ON indicates that the code is downloaded. OFF indicates that no application

microcode is downloaded. The default is ON.

AutoStart

indicates whether the SAC automatically starts after a system cold start. OFF

indicates that the SAC and its subordinate PIFs are left in the STOPPED state after

a cold start. ON indicates that the SAC and its subordinate PIFs automatically start

after a cold start. The default is ON.

AutoDump

indicates whether the SAC attempts to dump the contents of the adapter’s memory

before it restarts after a failure of the SAC object. OFF indicates that the SAC does

not dump the memory contents automatically. ON indicates that the SAC dumps

the information before it restarts. The default is ON.

AccessList

lists the processors that can have access to the SAC.

DlFilename

specifies the name of the file that contains the application microcode for the SAC.

FirmwareFilename

indicates the name of the file that contains the firmware microcode.

DumpFilename

indicates the name of the file to which the SAC dumps the contents of the

adapter’s memory if the SAC object fails.

SAC Type

indicates the type of SAC in use. The type is specified as either

MIOE SAC, E4SA

SAC, FESA SAC, GESA SAC, G4SA, or TRSA SAC

. A value of Adapter Mismatch

means that the SAC has been configured for an adapter type that differs from the