LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem

LAN Configuration and Management Manual—520469-012

4-76

RESET ADAPTER Command

The RESET ADAPTER command initiates a hardware reset of the adapter, putting it in

a known state. The ADAPTER object must be in the STOPPED state before you issue

this command.

Command Syntax

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file.

ADAPTER adapter-name

specifies which adapter to reset.

Considerations



This command initiates the hardware-reset operation.



The hardware reset turns off the LED that indicates a failure of the power-on

self-test (POST). The POST-fail LED turns on again only when a POST failure is

detected.



The command is not meaningful for the MFIOB.

Example

RESET ADAPTER $ZZLAN.E0153

START Command

START is a sensitive command that initiates the operation of the specified object.

When the SLSA subsystem has successfully completed processing this command, the

object is placed in the STARTED or STARTING state.

START ADAPTER Command

The START ADAPTER command initiates the operation of the ADAPTER object. When

the subsystem has successfully completed processing this command, the ADAPTER

object is placed in the STARTED state.

RESET [ /OUT

file-spec / ] ADAPTER adapter-name