LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-77
START ATMSAP Command
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
ADAPTER adapter-name
specifies the adapter to start.
SUB [ ONLY | ALL | NONE ]
directs the command at a set of subordinate objects.
ONLY specifies that only the subordinate objects are affected.
ALL specifies that the named object and the subordinate objects are affected.
NONE specifies that none of the subordinate objects are affected.
Considerations

You must start the ADAPTER object by using the START ADAPTER command
after adding the adapter to the system.

Omitting the SUB option has the same affect as SUB NONE.

Including the SUB option without specifying ALL, NONE, or ONLY has the same
affect as SUB ALL.
Example
The following example starts the adapter named G1123:
START ADAPTER $ZZLAN.G1123
START ATMSAP Command
The START ATMSAP command causes target ATMSAP objects to begin operation.
The ATMSAP objects enter the STARTED summary state if the command is
successful. The command is rejected if the ATMSAP object is already in the
STARTED summary state.
START [ /OUT
file-spec / ] ADAPTER adapter-name
[ , SUB [ ONLY | ALL | NONE ] ]
START [ /OUT file-spec/ ] ATMSAP atmsap-name