LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem

LAN Configuration and Management Manual—520469-012

4-79

START LIF Command

The START LIF command initiates the operation of the line interface (LIF) object.

When the subsystem has completed processing this command, the LIF object is

placed in the STARTED state.

Command Syntax

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file.

LIF lif-name

specifies the LIF to be placed in the STARTED state. The LIF name has the form

$ZZLAN.lif-name, for example, $ZZLAN.L11123C.

Considerations



You must start the LIF object by using the START LIF command after you add the

LIF object to the system.



The START LIF command can cause the PIF associated with the specified LIF to

briefly go into the STARTING state.



The START LIF command does not affect the access state of the LIF.

Example

The following example starts the LIF named L11123C:

START LIF $ZZLAN.L11123C

START MON Command

The START MON command initiates the operation of a LANMON process.

Command Syntax

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file.

START [ /OUT

file-spec / ] LIF lif-name

START [ /OUT

file-spec / ] MON lanmon-name