LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-102
STATS PIF Command
STATS PIF Display for a G4SA
DFC Events
is the data forwarded because of DATAFORWARDCOUNT (DFC) expiration.
DFT Events
is the data forwarded because of DATAFORWARDTIME (DFT) expiration.
Exec Rate
is the number of times each second that the main loop has been executed.
-> STATS PIF $ZZLAN.G11123.0.A
SLSA Stats PIF \SYS.$ZZLAN.G11123.0.A
Sample Time..... 29 Sep 2003, 12:34:23.098
Reset Time...... 29 Sep 2003, 12:34:23.098
DFC Events............................. 0
DFT Events............................. 0
Exec Rate.............................. 0
Exec Rate LWM.......................... 0
Out Frame Queue Length................. 0
In Frame Discard Errors................ 0
In Filter Frame Discards............... 0
In Filters Added For IP Fragments...... 0
TNET Nacks............................. 0
TNET Timeouts.......................... 0
802.3 Send Stats
Octets................................. 0
Packets................................ 0
Underrun Packets....................... 0
Single Collision Frames................ 0
Multi Collision Frames................. 0
Deferred Transmissions................. 0
Excessive Collision.................... 0
Late Collision......................... 0
Signal Quality Error Fail.............. 0
Transmit Errors........................ 0
Multicast Pkts sent by higher layer.... 0
Broadcast Pkts sent by higher layer.... 0
Carrier Sense Errors................... 0
Packets Discarded...................... 0
802.3 Receive Stats
Octets................................. 0
Packets................................ 0
FCS Errors............................. 0
Alignment Errors....................... 0
Control Pause Packets.................. 0
Overrun Packets........................ 0
Bad Packets............................ 0
Runt packets........................... 0
Packet Too Short Errors................ 0
Packet Too Long Errors................. 0
In Range Length Errors................. 0
Out Range Length Errors................ 0