LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-105
STATUS Command
FCS Errors
indicates a count of frames received on a particular interface that are an integral
number of octets in length and do not pass the FCS check.
Alignment Errors
indicates a count of frames received on a particular interface that are not an
integral number of octets in length and do not pass the FCS check.
Control Pause Packets
is the number of control pause packets received.
Overrun Packets
is the number of overrun packets received.
Bad Packets
is the number of packets with early termination caused by packet error.
Runt packets
is the number of runt packets received.
Packet Too Short Errors
is the number of short event packets received.
Frames Too Long
is a count of frames received on a particular interface that exceed the
maximum permitted frame size.
In Range Length Errors
indicates the frames that have a length not equal to actual bytes received.
Out Range Length Errors
indicates the frames that have a type greater than 1500 and less than 1536.
STATUS Command
STATUS is a nonsensitive command that displays the current settings of an object.
STATUS differs from INFO in that STATUS shows the current, dynamic settings for an
object, and INFO shows the configured, static settings. Fields common to both the
INFO and STATUS commands, such as line/interface speed, can differ; STATUS PIF
could show line speed of 10 Mbit/sec while INFO PIF could show 100 Mbit/sec. The
line speed could have changed from what was configured (shown by the INFO PIF
command) because of an incompatible line speed at the hub.