LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-117
STATUS PIF Command
Link Pulse State
indicates the current state of the link pulse on the physical Ethernet link. This field
is only applicable to the E4SA, FESA, GESA, and G4SA. The value of this field
can be UP (normal condition) or DOWN.
STATUS PIF DETAIL for a GESA
The format of the display for the STATUS PIF command with the DETAIL option for the
PIF on an GESA adapter is:
CPUs with Data Path
lists processors that have a successful data path for the specified PIF. NONE
indicates that no processor has a data path through the PIF. The processors are
listed in numerical order.
Last Error
indicates the severity, origin, and error code of the last error encountered by the
PIF. (0,0,0) indicates that no errors have occurred.
State
indicates the current state of the PIF.
Trace Filename
indicates the name of the file that stores current trace information if TRACE is ON
for the specified PIF.
Trace Status
indicates whether TRACE is active on the specified PIF.
Duplex
indicates whether the line is full-duplex, half-duplex, or invalid. Full-duplex means
that data can be sent and received at the same time. Half-duplex means that data
can be sent in only one direction at a time. Invalid means that the adapter is not
connected properly to the hub.
-> STATUS PIF G0154.0.A , DETAIL
CPUs with Data Path..... ( 0, 1, 2, 3 )
Interface Status . .OFF
Last Error.............. (3, LANMON, 2038)
State................... STARTED
Trace Filename..........
Trace Status............. OFF
GESA Adapter Status
Duplex...................... FULL
Line Speed.................. 1000 Mbit/sec
Link Pulse State............ Up