LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-121
STATUS PIF Command
Interface Type
The interface type can be T1, J1, or IP.
Duplex
The duplex mode can be half or full duplex.
Interface Speed
The interface speed is in Kbit/sec.
Ring State
indicates the current state of the token ring. This field is only applicable to the
TRSA (Token Ring ServerNet adapter). The value of this field can be one of the
following:
OPENED CLOSED
OPENING CLOSING
OPEN FAILURE RING FAILURE
Ring Open State
indicates the success, or the reason for failure, of the adapter’s most recent
attempt to enter the token ring. This field is only applicable to the TRSA (Token
Ring ServerNet adapter). The value in this field can be one of the following:
NO OPEN ATTEMPTED OPEN SUCCESSFUL BAD PARAMETER
LOBE FAILURE SIGNAL LOSS INSERTION TIMEOUT
RINGFAILED BEACONING DUPLICATE MAC ADDRESS
REQUEST FAILED REMOVE RECEIVED
Last Ring Status
is the current interface status of the token ring. This field is only valid if the Ring
State is OPENED. This field is only applicable to the TRSA (Token Ring ServerNet
adapter). The value in this field can be one of the following:
NO PROBLEMS RING RECOVERY SINGLE STATION
REMOVE RECEIVED AUTO REMOVAL ERROR LOBE WIRE FAULT
TRANSMIT BEACON SOFT ERROR HARD ERROR
SIGNAL LOSS