LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-130
STOP LIF Command
atmsap-id
is a 1 to 8-character alpha-numeric string that identifies the target ATMSAP
object. Wildcard characters are allowed.
Response Display
The STOP ATMSAP command returns only a success or failure indication. Successful
completion is indicated when SCF displays the prompt for the next command. A failure
is indicated when SCF displays an error message.
Example
STOP ATMSAP $ZZLAN.ATM01.0.A.ATMSAP01
STOP LIF Command
The STOP LIF command stops the operation of the specified LIF and places it in the
STOPPED state.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
LIF lif-name
is the name of the LIF to be put in the STOPPED state. The LIF name has the form
$ZZLAN.lif-name, for example, $ZZLAN.L11123A.
Considerations

Active clients (registered users) dependent on the LIF can prevent the STOP LIF
command from working. Use the ABORT LIF command if you cannot remove the
registered users of the specified LIF object.

You must use ABORT LIF if there are active clients on the LIF.

For all adapters but MIOF, if the LIF and PIF objects are in STARTED state, it is
assumed that there are active clients.

The STOP LIF command has no effect on the state of the PIF associated with the
specified LIF.
STOP [ /OUT
file-spec/ ] LIF lif-name