LAN Configuration and Management Manual

Managing the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
5-3
Adding an Adapter to the System
7. Assign logical interfaces (LIFs) to the PIFs on the adapter you added in step 3 by
using the SCF ADD LIF command. Use the names of the PIFs returned from the
system in step 5.
8. Start the LIFs by using the START LIF command.
9. Use the SCF STATUS commands to check that the adapter, SAC(s), PIFs, and
LIFs have started.
ADD LIF $ZZLAN.L11021A, PIF G11021.0.A
ADD LIF $ZZLAN.L11021B, PIF G11021.0.B
ADD LIF $ZZLAN.L11021C, PIF G11021.0.C
ADD LIF $ZZLAN.L11021D, PIF G11021.0.D
START LIF $ZZLAN.L11021A
START LIF $ZZLAN.L11021B
START LIF $ZZLAN.L11021C
START LIF $ZZLAN.L11021D
Note. To configure the TCP/IP subsystem for the LIFs added in step 6, refer to the TCP/IP
(Parallel Library) Configuration and Management Manual for Parallel Library TCP/IP
(supported on NonStop S-series systems only), the TCP/IP Configuration and Management
Manual for conventional TCP/IP, or the TCP/IPv6 Configuration and Management Manual for
NonStop TCP/IPv6.
STATUS ADAPTER $ZZLAN.G11021
SLSA Status ADAPTER
Name State
$ZZLAN.G11021 STARTED
STATUS SAC $ZZLAN.G11021.*
SLSA Status SAC
Name Owner State
$ZZLAN.G11021.0 0 STARTED
STATUS PIF $ZZLAN.G11021.*
SLSA Status PIF
Name State
$ZZLAN.G11021.0.A STARTED
$ZZLAN.G11021.0.B STARTED
$ZZLAN.G11021.0.C STARTED
$ZZLAN.G11021.0.D STARTED
STATUS LIF $ZZLAN.L111*
SLSA Status LIF
Name State Access State
$ZZLAN.L11021A STARTED UP
$ZZLAN.L11021A STARTED UP
$ZZLAN.L11021A STARTED UP
$ZZLAN.L11021A STARTED UP