LAN Configuration and Management Manual

Managing the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
5-6
Stopping and Starting an Adapter
7. Use the SCF STATUS PIF and SCF STATUS SAC commands to check the status
of the PIFs and SACs.
8. Verify that the adapter is in the STOPPED state by using the SCF STATUS
ADAPTER command.
9. Perform any management tasks, such as removing, then installing a ServerNet
adapter.
Starting an Adapter
Perform the following steps to start an adapter you have added or replaced:
1. Start the adapter and its associated SAC(s) and PIFs by using the SCF START
ADAPTER command, with the SUB ALL option. (This adapter might be the same
one you stopped in step 7, under Stopping an Adapter.)
2. After starting the adapter, use the SCF STATUS ADAPTER command to verify that
the adapter was started.
STATUS PIF $ZZLAN.G11021.*
SLSA Status PIF
Name State
$ZZLAN.G11021.0.A STOPPED
$ZZLAN.G11021.0.B STOPPED
$ZZLAN.G11021.0.C STOPPED
$ZZLAN.G11021.0.D STOPPED
STATUS SAC $ZZLAN.G11021*
SLSA Status SAC
Name Owner State
$ZZLAN.G11021.0 0 STOPPED
STATUS ADAPTER $ZZLAN.G11021
SLSA Status ADAPTER
Name State
$ZZLAN.G11021 STOPPED
START ADAPTER $ZZLAN.G11021, SUB ALL
STATUS ADAPTER $ZZLAN.G11021
SLSA Status ADAPTER
Name State
$ZZLAN.
G11021 STARTED