LAN Configuration and Management Manual

SCF Error Messages
LAN Configuration and Management Manual—520469-012
B-4
object-name
specifies the name of the object that generated the error.
SLSA 00009
Cause. The object you issued the command to is busy performing actions and cannot
process the SCF command.
Effect. SCF ignores the command.
Recovery. Wait, then try the command again. Contact your service provider if the
problem persists for a long time.
SLSA 00010
Cause. The SLSA subsystem received a START command for an object (specified by
object-name) whose parent is still in the STOPPED state. The object cannot be
started until the parent object is STARTED.
Effect. The specified object is not started.
Recovery. Start the parent object, then reissue the command.
SLSA 00011
Cause. A STOP or an ABORT command was received on an object that has one or
more subordinate objects not in the STOPPED state. Objects cannot be put in the
STOPPED state unless all subordinate objects are in the STOPPED state.
Effect. STOP or ABORT command has no effect on the state of the specified object.
Recovery. Check status of subordinate objects, and put all of them in the STOPPED
state, then reissue the command.
SLSA E00009 Object object-name is busy with other operations.
SLSA E00010 Cannot start object-name. Parent object is
still in STOPPED state.
SLSA E00011 Cannot stop object-name because subordinate
object is not stopped.