LAN Configuration and Management Manual

SCF Error Messages
LAN Configuration and Management Manual—520469-012
B-5
SLSA 00012
Cause. A LIF is preventing a LIF or a PIF from being stopped because the LIF and its
associated PIF have active clients. object-name specifies the LIF or a PIF that has
the registered clients.
Effect. You cannot stop the object specified by object-name.
Recovery. Identify the LIF involved (use the INFO LIF command), terminate all
registered clients of the LIF, then reissue the STOP command. Use the ABORT
command instead of the STOP command if you still cannot stop the object.
SLSA 00013
Cause. A LOAD or DUMP command issued by the system console failed during a
file-system operation on the firmware or dump file specified in the command. This
action caused the command to fail.
Effect. The firmware is not downloaded or the dump file is not generated.
Recovery. Make sure that the SAC object has a valid and correct firmware or dump
file name (use the INFO SAC or ALTER SAC command), then reissue the command.
SLSA 00014
Cause. The specified SCF command required use of QIO resources, but an error in
manipulating these QIO resources caused the command to fail.
Effect. SCF ignores the command.
Recovery. Check the condition that caused the given QIO error, resolve that condition,
then retry the SCF command.
SLSA 00015
Cause. An ADD LIF command was issued to a PIF that is already in use by a LIF. A
PIF can be used by only one LIF.
SLSA E00012 Object object-name has registered client(s) and
cannot stop.
SLSA E00013 Command for object object-name failed due file
system error error-number.
SLSA E00014 Command failed for object object-name due to QIO
error error-number.
SLSA E00015 PIF specified for lif-name is already in use by
another LIF.