LAN Configuration and Management Manual

SCF Error Messages
LAN Configuration and Management Manual—520469-012
B-7
SLSA 00019
Cause. A LOAD command was issued for a SAC object, specified by object-name,
whose previously specified firmware file does not contain a downloadable module that
is appropriate for that particular SAC object.
Effect. The firmware file is not downloaded to the SAC.
Recovery. Make sure that the SAC object has a valid and correct firmware file (use
the INFO SAC and ALTER SAC commands) then reissue the command.
SLSA 00020
Cause. A DUMP command was issued for a SAC object that is using invalid
dump-address information.
Two possible causes of bad dump-address information are:

The SAC never downloaded a valid application-download file because no such file
exists or because the SAC was never started.

The application-download file contains invalid dump-address information.
Effect. The dump is not performed.
Recovery. Make sure that a valid application-download file with valid dump address
information exists, then make sure that the application-download file downloads to the
adapter.
SLSA 00021
Cause. A command was issued and the current summary state of the target object
prevents processing of the command. This error is returned whenever the
state-transition specification is not met.
Effect. SCF ignores the command.
Recovery. Ensure that the target object is in a summary state compatible with the
command to be issued.
SLSA E00019 Firmware file for object-name does not contain an
applicable download module.
SLSA E00020 Invalid dump address information for object
object-name.
SLSA E00021 Command not allowed while object in state state
for object-name