LAN Configuration and Management Manual

SCF Error Messages
LAN Configuration and Management Manual—520469-012
B-9
SLSA 00026
Cause. The SLSA subsystem does not detect the adapter specified by object-name
because the adapter is not plugged in, or it is the process of being reset.
Effect. SCF ignores the command.
Recovery. Retry the SCF command. If this message persists, make sure that adapter
is correctly plugged in, then retry the command.
SLSA 00027
Cause. You specified an adapter type that does not match the type of adapter
installed in the system at the specified location.
Effect. SCF ignores the command.
Recovery. Check that the right adapter is in the right location. Then reconfigure
adapter type.
SLSA 00029
Cause. One or more attributes that you specified in an ALTER command does not
exist for the type of adapter you specified or cannot be changed for that adapter type.
For example, for PIF attributes, RINGSPEED is valid only for adapter type TRSA and
you can set NODEMACADDRESS only for adapter type TRSA. Attempting to set these
attributes for a PIF on an E4SA adapter type would cause error 29.
Effect. SCF ignores the command.
Recovery. Check that the object specified by object-name is correct. If you
specified the incorrect object name, reissue the command using the correct
object-name. Otherwise, the command is not supported for the given object.
SLSA E00026 Adapter corresponding to object-name is
configured but not detected at present
SLSA E00027 Adapter type of object-name does not match actual
physical adapter type
SLSA E00029 Adapter type of object-name does not support
changing of specified attribute(s)