LAN Configuration and Management Manual

SCF Error Messages
LAN Configuration and Management Manual—520469-012
B-11
Effect. SCF ignores the command.
Recovery. Remove the DATAFORWARDCOUNT and DATAFORWARDTIME
attributes from the ADD or ALTER command line. These two attributes are not
required for a LIF that is associated with an ATMSAP object.
SLSA 00051
Cause. You issued a STATUS command, however the status information is not
available for display. The object or its parent object is not in a started state.
Effect. SCF ignores the command.
Recovery. Start the object and/or parent object before issuing the status command.
SLSA 00052
Cause. You issued an SCF command, however the SCF command is not supported
by that particular object.
Effect. SCF ignores the command.
Recovery. See SLSA Subsystem SCF Objects on page 2-11 for further information.
SLSA 00056
Cause. You issued an ADD or ALTER command, and tried to assign an invalid value
to an attribute.
Effect. SCF ignores the command.
Recovery. Set the attribute to a value that is within the valid range.
SLSA 00060
Cause. You issued an ALTER PIF command on a FESA or GESA adapter.
You specified the AUTONEGOTIATE attribute to OFF, but the LINESPEED and
DUPLEX attributes were left unspecified.
Effect. SCF ignores the command.
SLSA E00051 Superior object not started for <obj name>
SLSA E00052 Command not valid for object <obj name>.
SLSA E00056 Attribute value invalid: <obj name>.
SLSA E00060 LINESPEED and DUPLEX required when AUTONEGOTIATE
is set to OFF