LAN Configuration and Management Manual

SCF Error Messages
LAN Configuration and Management Manual—520469-012
B-12
Recovery. Specify the LINESPEED and DUPLEX attribute settings in the ALTER PIF
Command.
SLSA 00061
Cause. You issued an ALTER PIF command on a FESA or GESA adapter. You
specified the AUTONEGOTIATE attribute to ON; however, you also specified the
LINESPEED and DUPLEX attributes in the command line.
Effect. SCF ignores the command.
Recovery. Delete the LINESPEED and DUPLEX attribute settings in the ALTER PIF
Command.
SLSA 00062
Cause. You issued a TRACE PIF or TRACE SAC command with the CPU attribute
specifying a CPU number that was not on the ACCESSLIST of the PIF or the SAC.
Effect. SCF ignores the command.
Recovery. Specify a valid CPU number in the TRACE command.
SLSA 00063
Cause. You issued a TRACE MON or PROCESS command with the CPU attribute
specified.
Effect. SCF ignores the command.
Recovery. Remove the CPU attribute in the TRACE command.
SLSA E000
61 LINESPEED and DUPLEX not required when
AUTONEGOTIATE is set to ON
SLSA E00062 CPU is not on the ACCESSLIST for objname
SLSA E00063 CPU attribute not supported for TRACE MON or
TRACE PROCESS command