LAN Configuration and Management Manual

SCF Error Messages
LAN Configuration and Management Manual—520469-012
B-14
Recovery. Issue the START MON command for the LANMAN’s backup CPU, then
retry the SWITCH PROCESS command.
SLSA 00068
Cause. The user issued a TRACE command but there is no LANMON to handle that
request in the specified CPU.
Effect. SCF ignores the command.
Recovery. Issue the START MON command, then retry the TRACE command.
SLSA 00071
Cause. The user attempted to specify an INTERFACE attribute value which is not
supported by the specified physical interface (PIF). G4SA adapters have four
configurable physical interfaces (PIFs). PIF A and PIF B can only be configured with
INTERFACE values COPPER or AUTODETECT; however, PIF C and PIF D can be
configured with INTERFACE values COPPER, FIBER, or AUTODETECT.
Effect. SCF ignores the command.
Recovery. Reissue the command with INTERFACE set to COPPER or
AUTODETECT, or specify a different physical interface (PIF) which supports the
specified INTERFACE value.
SLSA 00072
Cause. The user attempted to specify a DATAFORWARDTIME beyond the range of
the current DATAFORWARDUNIT
.
Effect. SCF ignores the command.
Recovery. Reissue the command with a DATAFORWARDTIME value that is between
1 and 200 milliseconds.
SLSA E00068 The MON in the specified cpu to be traced is
in the STOPPED state
SLSA E00071 The objname does not support the FIBER
INTERFACE type.
SLSA E00072 DATAFORWARDTIME is beyond the valid range of
1-200 MILLISECONDS