LAN Configuration and Management Manual

Configuration Quick Start
LAN Configuration and Management Manual—520469-012
1-3
Checking the State of the LAN Manager (LANMAN)
Process
Checking the State of the LAN Manager (LANMAN) Process
Use the SCF STATUS PROCESS command to determine the current state of the LAN
Manager (LANMAN) process:
Checking the State of the LAN Monitor (LANMON) Processes
Use the SCF STATUS MON command to determine the current state of each LAN
Monitor (LANMON) process. You must enter the ALLOW ALL ERRORS command
before using the wildcard (*) if your system has fewer than 16 processors.
Checking the State of the TCP/IP Processes
Use the appropriate SCF LISTDEV TCPIP command to get a list of all running TCP/IP
processes.
For conventional TCP/IP:
For Parallel Library TCP/IP:
For NonStop TCP/IPv6:
Use the SCF STATUS PROCESS command to determine the state of each
preconfigured TCP/IP process:
STATUS PROCESS $ZZLAN
Note. As of the G06.21 RVU, a new LANMON can be installed without a cold load. Refer to
Replacing a LANMON Without a Cold Load
on page 5-10 for more information.
ALLOW ALL ERRORS
STATUS MON $ZZLAN.#ZLM*
LISTDEV TCPIP
Note. Parallel Library TCP/IP is not supported on Integrity NonStop NS-series servers.
LISTDEV PTCPIP
LISTDEV TCPIPV6
STATUS PROCESS $tcpip process-name