LAN Configuration and Management Manual

Configuration Quick Start
LAN Configuration and Management Manual—520469-012
1-7
Installing an Adapter
Starting a PIF Object
If a PIF object is in the STOPPED state, use the SCF START PIF command to start it:
pif-name
is the name of the PIF object to start.
Starting a LIF Object
If a LIF object is in the STOPPED state, use the SCF START LIF command to start it:
lif-name
is the name of the LIF object to start.
Starting an ATMSAP Object
atmsap-name
is the name of the ATMSAP object to start.
Installing an Adapter
After you verify the initial SLSA subsystem configuration as described on page 1-2, you
can install additional adapters. For information, see:
START PIF $ZZLAN.pif-name
START LIF $ZZLAN.lif-name
START ATMSAP $ZZLAN.atmsap-name
Adapter Manuals (page1of2)
6763 Common Communication ServerNet Adapter Installation and Support Guide for the
CCSA
ATM Adapter Installation and Support Guide for the ATM3SA
Ethernet Adapter Installation and Support Guide for the E4SA
Fast Ethernet Adapter Installation and Support Guide for the FESA
Fibre Channel ServerNet Adapter Installation and Support Guide for the FCSA
Gigabit Ethernet Adapter Installation and Support Guide for the GESA
Gigabit Ethernet 4-Port Adapter Installation and Support Guide for the G4SA
NonStop S-Series Hardware Installation and Fast Path Guide for the MFIOB
Token-Ring Adapter Installation and Support Guide for the TRSA
SWAN Concentrator Installation and Support Guide for the SWAN Concentrator (T3880)