LAN Configuration and Management Manual

Configuration Quick Start
LAN Configuration and Management Manual—520469-012
1-8
Changing the Initial SLSA Subsystem Configuration
Changing the Initial SLSA Subsystem
Configuration
After installing your adapter, you might want to change the initial SLSA subsystem
configuration. For example, you could:

Assign the IP addresses to different LIF objects

Add additional adapters

Reconfigure the TCP/IP processes assigned to the SLSA subsystem
SLSA subsystem management tasks like these are described in Section 5, Managing
the SLSA Subsystem.
WAN Wizard Pro
WAN Wizard Pro provides a graphical user interface (GUI) that guides you through the
configuration of wide area network (WAN) and local area network (LAN) hardware and
software.
WAN Wizard Pro can be used as an alternative to Subsystem Control Facility (SCF) to
configure the following LAN adapters:
Depending on your RVU, access WAN Wizard Pro from the taskbar on your system
console using one of the following methods:

For G06.21 RVU and later RVUs, including H-series RVUs:
Start>Programs>HP WAN Wizard Pro>WAN Wizard Pro

For G06.20 RVU and earlier RVUs:
Start>Programs>Compaq TSM>Guided Configuration Tools>WAN Wizard Pro
SWAN 2 Concentrator Installation and Support Guide for the SWAN 2 Concentrator (T3881)
Versatile I/O Manual
WAN Subsystem Configuration and Management Manual (SWAN and SWAN 2
concentrator configuration information)
ATM 3 ServerNet adapters (ATM3SAs)
6763 Common Communications ServerNet adapters (CCSAs)
Ethernet 4 ServerNet adapters (E4SAs)
Fast Ethernet ServerNet adapters (FESAs)
Gigabit Ethernet ServerNet adapters (GESAs)
Gigabit Ethernet 4-port ServerNet adapters (G4SAs)
Token-Ring ServerNet adapters (TRSAs)
Adapter Manuals (page2of2)