LAN Configuration and Management Manual

Introduction to the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
2-13
SLSA Subsystem SCF Objects
Supported Adapters by NonStop System Type

Adapters for NonStop S-Series systems

Adapters for NonStop NS-Series

Adapters for NonStop BladeSystems (J06.03 and Later RVUs)
Adapters for NonStop S-Series systems

Multifunction I/O Board/Ethernet (MFIOB)

ATM ServerNet Adapter (ATM3SA)

Ethernet 4 ServerNet adapter (E4SA)

Fast Ethernet ServerNet adapter (FESA)

Gigabit Ethernet ServerNet adapter (GESA)

6763 Common Communication ServerNet Adapter (CCSA)

Token-Ring ServerNet adapter (TRSA)

Gigabit Ethernet 4-port ServerNet adapter (G4SA)
Adapters for NonStop NS-Series

G4SAs are the only adapter that can be directly installed in a NonStop NS-series
system’s IOAM enclosure.

Adapters for NonStop S-Series systems can also connect to NonStop NS-series
systems if your system model supports these connections. To determine if your
NS-series system supports connections to S-series I/O enclosures, see your
installation documentation (for example, the NonStop NS16000 Hardware
Installation Manual).
Adapters for NonStop BladeSystems (J06.03 and Later RVUs)
Three ServerNet adapters are supported on NonStop BladeSystems:

Gigabit Ethernet 4-port ServerNet adapter (G4SA)
G4SAS can only be installed in an IOAM. Up to 4 IOAMs can be installed in a
NonStop BladeSystem enclosure.

6763 Common Communication ServerNet Adapter (CCSA)
CCSA-2 adapters in a NonStop S-series I/O enclosure provide SS7
connectivity to NonStop BladeSystems via IOMF2 CRU to c7000 ServerNet
switch connections.

Token-Ring ServerNet adapter (TRSA)
TRSAs in a NonStop S-series I/O enclosure provide token-ring connectivity to
NonStop BladeSystems via IOMF2 CRU to c7000 ServerNet switch
connections.
Note. G4SAs interoperate with NonStop S-series systems but cannot be directly installed
in an S-series enclosure.