LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem

LAN Configuration and Management Manual—520469-012

4-11

ABORT MON Command

The ABORT MON command stops the operation of the specified LAN Monitor

(LANMON) and places the LANMON in the STOPPED state.

Command Syntax

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file.

MON lanmon

is the name of the LANMON to be aborted. The LANMON name has the form

$ZZLAN.lanmon, for example, $ZZLAN.#ZLM01.

Considerations



The ABORT MON command will not work on a LANMON that is running in the

same CPU as the primary LANMAN.



No wildcards are allowed with this command.



ABORT [ /OUT file-spec/ ] MON lanmon

Effects of the ABORT MON command on Clients/NonStop TCP/IP (page1of2)

SLSA Clients When a LANMON is ABORTED, any SLSA clients lose LIF/PIF

access from the associated CPU. LANMON delays five

seconds after receiving the ABORT message after which

LANMON removes its QIO queues and detaches from the QIO

segment. At this point any clients that call

SM_LIF_GET_INFO_(),

from the CPU in which no LANMON is running, get error

zsm_err_dr_inv_dev_name. The delay in LANMON allows

clients enough time to call SM_LIF_GET_INFO_() in case they

need to switch