LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem

LAN Configuration and Management Manual—520469-012

4-15

ADD Command

ADD is a sensitive command that defines an object to the SLSA subsystem. The

fully-qualified name assigned to the created object must be unique.

If an attribute for a given object is not assigned a value in the ADD command, the

attribute's default value is used. However, some attributes do not have default values:

use the ADD command to assign values.

The ADD command does not support wild-card characters.

ADD ADAPTER Command

The ADD ADAPTER command assigns a name to a ServerNet adapter and also

names the SACs and PIFs related to the specified adapter.

Command Syntax

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file.

ADAPTER adapter-name

specifies the name to be assigned to the adapter. The names that the SLSA

subsystem assigns to the SACs and PIFs are based on the name you assign to the

adapter. For example, if you assign the name G11123 to a G4SA, the SAC on the

adapter is named G11123.0. The PIF names are G11123.0.A, G11123.0.B,

G11123.0.C, and G11123.0.D. SLSA treats the Ethernet ports in slots 6 and 7 of

the VIO enclosure as G4SAs. (The VIO enclosure is available in H06.08 and

subsequent H-series RVUs.)

ADD [ /OUT file-spec/ ] ADAPTER adapter-name

{ , TYPE { E4SA|MIOE|TRSA|FESA|GESA|G4SA|CCSA|ATM3SA} }

{ , LOCATION (group,module,slot) }

{ , ACCESSLIST ( n0 , n1,..., n15 ) }

[ , AUTODUMP { ON | OFF| EXTENDED } ]

[ , AUTOFIRMUP { ON | OFF } ]

[ , AUTOSTART { ON | OFF } ]

[ , DLFILENAME file-spec ]

[ , DUMPFILENAME file-spec ]

[ , FIRMWAREFILENAME file-spec ]