LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-22
ADD ATMSAP Command
MTU max-mtu-size
configures the maximum message transfer unit size for the ATMSAP.
Valid values:
max-mtu-size is a decimal number in the range 1 through 9180.
Default value: 9180
NATURE { PVC }
configures the virtual connection nature of the ATMSAP component and selects the
connection supported for the ATMSAP object. Only PVC type connections are
supported.
Valid values:
PVC: ATMSAP object uses a PVC connection
QOSSET { UBR }
configures the Quality of Service for the ATMSAP object. Only UBR is supported.
Valid values:
UBR: Unspecified bit rate.
VCC ( vpi,vci )
vpi configures the virtual path identifier. vci configures the virtual circuit identifier.
This is a required parameter if NATURE PVC is selected.
Valid values:
Response Display
The ADD ATMSAP command returns only a success or failure indication. Successful
completion is indicated when SCF displays the prompt for the next command. A failure
is indicated when SCF displays an error message. In case of failure, additional
information can be found in the EMS log.
Value Description
vpi
Configures the virtual path identifier. Only vpi 0 is
supported.
vci
Configures the virtual circuit identifier. The virtual circuit
identifier is a number in the decimal range of 0 to 4096.