LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-28
ALTER ATMSAP Command
$ZZLAN.adapter-id.sac-id.pif-id.atmsap-id
where:
adapter-id
is a 1 to 8-character alpha-numeric string, beginning with an alpha character,
that identifies the parent SLSA ADAPTER. Wildcard characters are not
allowed.
sac-id
is a number that identifies the parent SAC object. The only valid sac-id for the
ATM3SA adapter is the number “0.” Wildcard characters are not allowed.
pif-id
is an alpha character that identifies the parent PIF object. The only valid pif-id
for the ATM3SA adapter is the letter “A.” Wildcard characters are not allowed.
atmsap-id
is a 1 to 8-character alpha-numeric string that identifies the target ATMSAP
object. Wildcard characters are not allowed.
MTU max-mtu-size
max-mtu-size configures the maximum message transfer unit size for the ATMSAP
object.
Valid values:
max-mtu-size is a decimal number in the range of 1 through 9180.
NATURE {PVC}
configures the virtual connection nature of the ATMSAP component. Only PVC is
supported.
Valid values:
PVC: ATMSAP uses a PVC connection.
QOSSET { UBR }
configures the Quality of Service for the ATMSAP object. Only UBR is supported.
Valid Values:
UBR: Unspecified bit rate.
VCC (vpi,vci)
vpi configures the virtual path identifier. vci configures the virtual circuit identifier.
This is a required parameter if NATURE PVC is selected.