LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-33
ALTER PIF Command
sac-id
is a number that identifies the parent SAC objects. Wildcard characters are
allowed.
pif-id
is an alpha character that identifies the target PIF objects. Wildcard characters
are allowed.
ACTIVEMONITOR { ON | OFF }
specifies whether the adapter participates in the token-ring monitor function. Set it
to ON for the node to participate as a standby or active monitor on the token-ring.
The default is OFF. ACTIVEMONITOR is supported for TRSAs only.
AUTONEGOTIATION { ON | OFF }
Select ON to enable automatic speed negotiation from the FESA, GESA, or G4SA
PIF. Select OFF to disable automatic speed negotiation from the FESA, GESA, or
G4SA PIF. When AUTONEGOATION is set to OFF, you must also specify the
DUPLEX and LINESPEED attributes. AUTONEGOTIATION is supported for
FESAs, GESAs, and G4SAs only. The default is ON.
INTERFACE {AUTODETECT | COPPER | FIBER}
is supported for G4SA adapter types only. Select COPPER for PIF C or PIF D to
use the 10/100/1000 copper ports. Select FIBER for PIF C or PIF D to use the
1000 fiber ports. Select AUTODETECT for PIF C or PIF D to automatically detect
the interface type upon connection. (COPPER and AUTODETECT are the only
possible settings for PIF A and PIF B.) The default is AUTODETECT.
DATAFORWARDCOUNT df-count
configures the maximum number of inbound frames queued before delivery
occurs. df-count is the maximum number of frames queued. This attribute is
supported for ATM3SAs only. The value of df-count is in the range of 1 through 50.
The default value is 2. This attribute is supported for ATM3SAs only.
Valid values:
The range is 1 through 50.
Default value is 2.
DATAFORWARDTIME df-time
configures the maximum time an inbound frame waits before delivery. df-time is
the time to wait. df-time is specified as a time interval in the form ttt, where ttt is an
integer in which each unit is a millisecond. The value of df-time is in the range of
Note. HP recommends AUTONEGOTIATION to be set to ON for the fiber ports
PIF C and PIF D.