LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-37
ALTER SAC Command
SAC sac-name
is the name of the SAC to be altered. The SAC name has the form
$ZZLAN.adapter-name.sac-unit#, for example, $ZZLAN.G1123.0.
ACCESSLIST ( n0 , n1,..., n15)
specifies the processors allowed to access the SAC. The first processor in the list
is the preferred owner. You must specify at least two processors in the access list.
The allowed number of processors in the access list is 2 to 16.
AUTODUMP { ON | OFF | EXTENDED}
specifies whether the SAC dumps information to a file if the SAC fails.
AUTODUMP does not apply to the MIOE. AUTODUMP with the EXTENDED
option only applies to the G4SA. AUTODUMP ON is the default. For the G4SA, if
the attribute is ON, just the adapter data structures are dumped. If the attribute is
set to EXTENDED, the data structures and I/O buffers are dumped. For the G4SA,
this attribute can be changed even when the SAC is in the STARTED state. The
EXTENDED option is recommended for use by HP support only.
AUTOFIRMUP { ON | OFF }
indicates whether the SAC automatically downloads the firmware prior to
downloading the operation code if the version of the firmware file is newer than the
firmware version on the adapter. ON indicates that the SAC automatically updates
the firmware. OFF indicates the firmware is not updated automatically. The default
is ON. The AUTOFIRMUP option does not apply to the MFIOB.
AUTOSTART { ON | OFF }
specifies that the system automatically starts the SAC after a system-load when
this option is ON. If this option is set to OFF, you must start the SAC by using a
START SAC command after the cold load. The default is ON.
DLFILENAME
file-spec
specifies the file from which the SLSA subsystem obtains the application
microcode to be downloaded to the SAC when the SAC changes from a
STOPPED state to a STARTING state.
FIRMWAREFILENAME
file-spec
specifies the name of the file that contains the firmware microcode to be loaded
into the flash programmable ROM (PROM) of the specified SAC the next time the
system console runs a FIRMUP command or AUTOFIRMUP occurs.
DUMPFILENAME
file-spec
specifies the name of the file to which the adapter dumps diagnostic information
when it detects a failure or when OSM or TSM initiates a dump of the adapter.