Measure Reference Manual

Example
To display all plot attributes:
+ SHOW PLOT
Set Plot Vert-Base on
Set Plot Time-Base
Set Plot Scale-From 0.000
Set Plot Scale-To 100.000
Set Plot Wide-Item off
Set Plot From
Set Plot To
Set Plot For
SHOW REPORT
The SHOW REPORT command displays the setting of one or all report attributes.
Syntax
SHOW [ / OUT filename / ] [ REPORT ] [ attribute ]
OUT filename
directs command output to filename. If filename does not exist, MEASCOM creates an
EDIT file by that name and writes command output to it. If filename does exist, MEASCOM
opens the file and appends command output to it.
Following execution of the SHOW REPORT command, MEASCOM redirects its output to the
current OUT file (typically, the terminal). This attribute does not affect the contents of the log
file.
REPORT
is optional if you specified it as the command object by using the ASSUME command.
attribute
is one of:
TOFORMATCR-NAME-FORM
TOTALSFROMCR-NAME-LEN
ZERO-REPORTSLOADIDCR-NAME-QUAL
ZERO-VALUESRATEDOTS
STYLEFOR
For descriptions of these attributes, see SET REPORT (page 109).
If you omit attribute, MEASCOM displays all attributes.
Related Commands
PageFunctionCommand
104Resets the report format options to default valuesRESET REPORT
109Sets the report format optionsSET REPORT
Usage Note for All PVUs and RVUs
The SHOW REPORT command output is a list of the commands used to set the report attributes.
Use /OUT filename/ to create a command (OBEY) file that you can later use to restore the
current set of attributes.
118 MEASCOM Commands