Measure Reference Manual

Devices connected by an FCSA or CLIM are dual fabric adapters, that is, they are connected
to both the X and Y fabrics. For these disks, only "*" or "X" should be specified in the LIST
command, and only "X" should be specified in the LISTACTIVE command.
group
(G-series and later RVUs) is the group number of the device to measure. (The group
corresponds to the physical enclosure.) To indicate all groups, use an asterisk (*). The
default is all groups.
module
(G-series and later RVUs) is the module number of the device to be measured. To indicate
all modules, use an asterisk (*). The default is all modules.
slot
(G-series and later RVUs) is the slot number of the device to be measured. To indicate all
slots, use an asterisk (*). The default is all slots.
scsi-id
(G-series and later RVUs) is the SCSI port identifier of the device to be measured. To indicate
all SCSI ports, use an asterisk (*). The default is all SCSI ports. This value is used for
ServerNet/DA and FCSA devices, but not for CLIM devices.
sac
is the name of the CLIM. Only one CLIM name is supported for the DEVICE entity.
lun
is the logical unit number assigned to a disk within a CLIM. The HP NonStop operating
system supports a range of 0 to 65535 for lun. Measure supports a range of 0 to 65534,
after reserving 65535 (-1) for the wildcard (*). lun can only be specified for CLIM devices.
The default is all luns.
chan
(D-series) is the channel number of the device to measure. The default is all channels.
ctrl
(D-series) is the controller number of the device to be measured (0 through 31). The default
is all controllers.
unit
(D-series) is the unit number of the device to be measured. The default is all units.
DDL Record for DEVICE Entities (ZMS Style)
The ZMS Style DDL record for DEVICE entities is supported on Measure G11 and later PVUs.
The fields included in BRIEF reports are in boldface type.
ID Fields DDL Definition
DEFINITION zmsdev-id.
02 pin type binary 16 unsigned.
02 device-type type binary 16 unsigned.
02 device-subtype type binary 16 unsigned.
02 servernet type binary 16 unsigned.
02 device-name type character 8.
02 logical-device type binary 32 unsigned.
02 GMS.
03 group type binary 32 unsigned.
03 module type binary 32 unsigned.
03 slot type binary 32 unsigned.
02 SCSI-id type binary 64.
02 plpt redefines SCSI-id.
03 plpt-flags type binary 8 unsigned.
03 path type binary 8 unsigned.
180 Entities and Counters