Measure Reference Manual

Disks connected by an FCSA or CLIM are dual fabric adapters, that is, they are connected
to both the X and Y fabrics. For these disks, only "*" or "X" should be specified in the LIST
command, and only "X" should be specified in the LISTACTIVE command.
group
(G-series and later RVUs) is the group number of the disk to be measured. (The group
number corresponds to the physical enclosure.) To indicate all groups, use an asterisk (*).
The default is all groups.
module
(G-series and later RVUs) is the module number of the disk to be measured. Use an asterisk
(*) to indicate all modules. The default is all modules.
slot
(G-series and later RVUs) is the slot number of the disk to be measured. To indicate all slots,
use an asterisk (*). The default is all slots.
scsi-id
(G-series and later RVUs) is the SCSI port identifier of the disk to be measured. To indicate
all SCSI ports, use an asterisk (*). The default is all SCSI ports. This value is used for
ServerNet/DA and FCSA disks, but not for CLIM disks.
path
applies to FCSA storage disks as well as storage CLIM disks. Valid values for path can
be “-P”, “-B”, “-M” or “-MB” (specifying primary, backup, mirror, mirror-backup,
respectively). If path is specified, values specified for svnet, sac, lun, and partition are
ignored.
sac
is the name of the SAC the disk is connected to. If the device is a CLIM device, sac is the
name of the CLIM(s). Up to two CLIM names are supported. If two CLIM names are specified,
they must be enclosed by parentheses with a comma separating the two names. The default
is all CLIMs.
lun
is the logical unit number assigned to a disk within a CLIM. The NonStop operating system
supports a range of 0 to 65535 for lun. Measure supports a range of 0 to 65534, after
reserving 65535 (-1) for the wildcard (*). The default is all luns.
partition
is the number assigned to a partition within a partitioned disk. The default is all partitions.
Only valid for CLIM-attached disks beginning with H06.23/J06.12 and later RVUs.
channel
(D-series) is the channel number of the disk to be measured. The default is all channels.
ctrl
(D-series) is the controller number of the disk to be measured. The default is all controllers.
unit
(D-series) is the unit number of the disk to be measured. The default is all units.
190 Entities and Counters