Measure Reference Manual

line
(G-series) is 0 or 1 to indicate a specific line managed by a CLIP in a 3880 SWAN
concentrator. To indicate all lines, use an asterisk (*).
type
(G-series) is a type number to indicate a particular protocol, such as 61 (X.25). Use SCF
LISTDEV to see valid values for line types. To indicate all line types, use an asterisk (*).
subtype
(G-series) is a subtype number, such as 62 (X25AM). To see valid subtype numbers, use
SCF LISTDEV. The default is all subtypes that apply to type.
chan
(D-series) is the channel number of the measured terminal. The default is all channels.
ctrl
(D-series) is the controller number of the measured terminal. The default is all controllers.
unit
(D-series) is the unit number of the measured terminal. The default is all units.
DDL Record for TERMINAL Entities (ZMS Style)
The ZMS Style DDL record for TERMINAL entities is supported in Measure G11 and later PVUs.
The fields included in BRIEF reports are in boldface type.
ID Fields DDL Definition
DEFINITION zmsterm-id.
02 terminal-name.
03 line-name type character 8.
03 subdev-name type character 8.
02 logical-device type binary 32 unsigned.
02 reserved-1 type character 4.
end
Counter Fields DDL Definition
DEFINITION zmsterm-ctrs.
02 requests type binary 64.
02 reads type binary 64.
02 writes type binary 64.
02 input-bytes type binary 64.
02 output-bytes type binary 64.
02 transactions type binary 64.
02 response-time type binary 64.
end
DDL Record Description Fields
RECORD zmsterm. FILE is "zmsterm" ENTRY-SEQUENCED.
02 hdr type zmsheader.
02 ctr type zmsterm-ctrs.
02 id type zmsterm-id.
end
DDL Record for TERMINAL Entities (Legacy Style)
The Legacy Style DDL record for TERMINAL entities will not change after the Measure G10 PVU.
The fields included in BRIEF reports are in boldface type.
358 Entities and Counters