Measure Reference Manual

Cause
The ADD MEASUREMENT command was issued for a data file that was previously added, and
the MEASFH process is still active.
Effect
The recent ADD MEASUREMENT command changes the current data file, but the MEASFH
program file name remains unchanged.
Recovery
To use a different MEASFH process on the same data file during a session, use the DELETE
MEASUREMENT command to delete the current MEASFH process, then reissue the ADD
MEASUREMENT command to specify a new MEASFH process.
MEAS 3013
WARNING. Measurement in the current data file is from
current-datafile-version, which is a later release than this version
(current-meascom-version) of MEASCOM.
Cause
Measurement in the current data file is from a later RVU than the version of the running
MEASCOM. The later RVU might have changes in the external record format.
Effect
The data file is added.
Recovery
If you are certain there are no differences in the external record format between the two RVUs,
you can disregard this warning message. Otherwise, use a MEASCOM from the same or later
RVU of that in the data file.
MEAS 3014
WARNING. The specified Loadid has more than 5 characters, sequencing
will be suppressed.
Cause
A three-digit sequence-ID was added to LOADID to designate each interval of the measurement
when the LISTALL command is used. It was suppressed because three characters were not
available for use.
Effect
Sequencing is suppressed.
Recovery
Use five or fewer characters for LOADID.
MEAS 3015
WARNING. MEASCOM is attempting to allocate or resize its extended segment
to be number bytes.
Cause
MEASCOM is requesting an extended segment larger than 16 MB.
Effect
The command continues unless a system error is encountered, in which case the error is displayed.
Recovery
If the segment is considered to be too large, stop MEASCOM, and specify the LIST command
in a way that decreases the number of records returned to MEASCOM. (For example, use the
IF clause.)
498 Error Messages