N1524A ACL Installation and User's Guide for the NonStop S-Series Tape Enclosure

Error Recovery Procedures and Fault Symptom
Codes
N1524A ACL Installation and User’s Guide for the NonStop S-Series Tape Enclosure—527340-001
C-13
Inter-module Error Codes
6015 Ack Timeout - Out The Master inter-module process attempted to
initiate a packet transmission to a Slave inter-
module process, but a timeout occurred waiting
for the Slave's acknowledge.
A, B, 1
6016 Ack Timeout - In The Master inter-module process attempted to
initiate a packet transmission from a Slave inter-
module process, but a timeout occurred waiting
for the Slave's acknowledge.
A, B, 1
6017 Ack Invalid - Out The Master inter-module process attempted to
initiate a packet transmission to a Slave inter-
module process, but the Slave's acknowledge
was invalid.
A, B, 1
6018 Ack Invalid - In The Master inter-module process attempted to
initiate a packet transmission from a Slave inter-
module process, but the Slave's acknowledge
was invalid.
A, B, 1
6019 Comm Port Ack Error The Master inter-module process, after sending a
control byte to a Slave, was waiting for an
acknowledge, but the UART detected an error
condition.
A, B, 1
6020 Command Overlap The Master inter-module process received a
Command from the Master control process, but a
previously issued command is still being
executed.
A, B, 1
6021 Slave RTS Still Set The Master inter-module process has received a
valid acknowledge from a Slave, but the Slave's
RTSi line has remained asserted.
A, B, 1
6022 Slave Addr Invalid The Master inter-module process received a
CommBlock from the Master control process, but
the specified Slave address exceeds the
maximum valid range.
A, B, 1
6023 Slave Req Unknown The Master inter-module process detected an
active SRVREQ line, but, after sequencing
through all slave addresses, determined that no
Slave had its RTSi line asserted.
A, B, 1
6024 Slave Has No Pkts The Master inter-module process is requesting
the Slave to send a packet, but the Slave has no
packets to send.
A, B, 1
6025 Pkt ID Invalid A, B, 1
6026 No Slaves to Flash D, 1
6027 Master Has No Flash D, 1
6028 Slave Unavailable D, 1
6029 Slave Has No Flash D, 1
6030 Slave Dev. Incompat. D, 1
FSC Message Description ERP