N1524A ACL Installation and User's Guide for the NonStop S-Series Tape Enclosure

Contents
N1524A ACL Installation and User’s Guide for the NonStop S-Series Tape Enclosure527340-001
iv
C. Error Recovery Procedures and Fault Symptom
Codes (continued)
C. Error Recovery Procedures and Fault Symptom
Codes (continued)
Inter-module Error Codes C-12
Boot Error Codes C-15
Flash Error Codes C-16
Safety and Compliance
Index
Figures
Figure 1-1. Example of the Tape Drive Configuration 1-2
Figure 1-2. Two N1524A ACL Tape Drives in a NonStop S-series Enclosure 1-7
Figure 1-3. Dimensions of the Enclosure 1-9
Figure 1-4. Tape Enclosure with a Rear Cover Attached 1-10
Figure 1-5. Two Stacked Tape Enclosures 1-11
Figure 1-6. Tape Enclosure on System Enclosure 1-12
Figure 1-7. System Enclosure on a Tape Enclosure 1-12
Figure 1-8. C7972A Tape Cartridge 1-14
Figure 2-1. Location of Power Switch 2-2
Figure 2-2. Location of AC Power Receptacle and SCSI Connections 2-2
Figure 2-3. Default Screen 2-4
Figure 2-4. Main Menu 2-5
Figure 2-5. Configure Menu 2-6
Figure 2-6. Set SCSI Menu 2-7
Figure 2-7. Set SCSI Menu Scrolled 2-8
Figure 4-1. Control Panel 4-2
Figure 4-2.
POST Screen 4-5
Figure 4-3.
Initialization Screen 4-6
Figure 4-4. Default Screen 4-7
Figure 4-5. Fault Screen 4-9
Figure 4-6. Tape Drive Menu Structure 4-10
Figure 4-7. Main Menu 4-11
Figure 4-8. Show Status Menu 4-13
Figure 4-9. Library Status Menu 4-14
Figure 4-10. Drive Status Menu 4-16
Figure 4-11. Map Information Menu 4-18
Figure 4-12. Security Menu 4-20
Figure 4-13. Code Select Menu 4-21