N1526A and N1527 ACL Tape Drive Installation and User's Guide
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Overview and Features
- 2 Setting Up the ACL Tape Drives
- 3 Installing and Configuring the ACL Tape Drive for the NonStop S-Series Server
- 4 Operation
- 5 Maintenance
- 6 Troubleshooting
- A Specifications
- Safety and Compliance
- Index
N1526A and N1527A ACL Tape Drive Installation and User’s Guide—542756-003
3-1
3
Installing and Configuring the ACL
Tape Drive for the NonStop S-Series
Server
This section includes these topics:
Installation
1. Check that the power switch on the tape drive is set to the off position. See
Figure 3-1.
2. Connect the power cord to the tape drive’s AC power receptacle. See Figure 3-1.
3. Make sure the power cord is fully seated.
Installation 3-1
Configuration 3-5
Note. Do not attach the male end of the power cord to a power outlet at this time.