NBT Manual

NBT Event Messages

NBT Manual—424773-001

A-7

znbt-evt-parm-error

Cause. Either param-name is an invalid PARAM for NBT, or param-value is

syntactically incorrect or out of range.

Effect. The PARAM is ignored and NBT starts up with default values for the particular

PARAM. If param-name is GFTCOM^XXX, then one or two, but not all three, of the

GFTCOM^OBJECT, GFTCOM^IN, and GFTCOM^OUT PARAMs were specified.

Recovery. Correct param-name and param-value, then stop and restart NBT.

znbt-evt-reply-error

Cause. NBT received a NonStop file system error fecode when replying to an

application request.

Effect. This message provides additional information useful when other errors are

detected.

Recovery. No action is required. If other problems are detected, include this

information in a trouble report.

znbt-evt-starting

Cause. This message is displayed at NBT startup time. program-name includes the full

NBT version and release date.

Effect. This message is given for your information only.

Recovery. No action is required.

znbt-evt-stopping

Cause. An NBTCOM SHUTDOWN command was received.

Effect. NBT stops immediately, returning error code 201 to any outstanding application

file system requests, and terminating any active sessions with remote nodes. If the

backup was running, a separate znbt-evt-event-backup-stopped event is generated. The

TACL STOP process-name command can equivalently be used to stop NBT.

Recovery. No action is required.

pname Error in PARAM param-name param-value

pname Reply error fecode

pname program-name program starting copyright

pname Process stopping - SHUTDOWN command