NBT Manual

NBT Event Messages

NBT Manual—424773-001

A-5

znbt-evt-exit-debug

Cause. NBT is resuming operation after an NBTCOM DEBUG command.

Effect. Various application timeouts or remote session timeouts can be expected while

NBT is in debug mode, or just after debug mode is exited.

Recovery. No action is required.

znbt-evt-gftcom-start-err

Cause. NBT could not start the NBTCOM process from object file fname.

Effect. status1 and status2 are the results from NEWPROCESS.

Recovery. Correct PARAM GFTCOM^OBJECT and restart NBT.

znbt-evt-info-subnet

Cause. An unusual error occurred while trying to communicate with the TCP/IP

process to retrieve the TCP/IP subnet configuration.

Effect. NBT was unable to communicate with the TCP/IP process.

Recovery. Try the SCF command INFO SUBNET subnet-name. If there is a problem,

correct it and NBT should automatically recover within one minute. If the problem

persists, contact your Compaq support representative.

znbt-evt-logon-suspended

Cause. wsname is the NetBIOS machine name of the remote workstation that has failed

three consecutive RMPCCOM logon attempts, and it suspends for one minute from

further logon attempts.

Effect. This may signify an attempt to defeat security.

Recovery. NBT will automatically allow further logon attempts from the workstation

after one minute.

pname Process exiting debug

pname Error status1 status2 starting GFTCOM^OBJECT fname

pname Domain domain Info Subnet subnet-name

error status status1 / status2

pname Too many logon failures - workstation wsname suspended