NBX Manual

NBX Event Messages

NBX Manual—424774-001

A-4

znbx-evt-cpuswitch

Cause. An NBXCOM CPUSWITCH command was received.

Effect. This is normally used only for NBX backup testing. The NBX primary process

stops, and the backup process will take over automatically.

Recovery. No action is required.

znbx-evt-domain-down

Cause. NBX has lost contact with NonStop IPX/SPX, and all activity on the domain is

stopped.

Effect. The NBXCOM STATUS DOMAIN command will provide some additional

information. This usually indicates a problem with the NonStop IPX/SPX subsystem.

Recovery. No action is required in NBX, as NBX will automatically retry connection to

NonStop IPX/SPX every minute.

znbx-evt-domain-up

Cause. NBX has contacted NonStop IPX/SPX and is ready for sessions. This appears

after ADD DOMAIN, after a backup takeover, or after NonStop IPX/SPX became

available again after an outage.

Effect. NBX is available for use.

Recovery. No action is required.

znbx-evt-enter-debug

Cause. An NBXCOM DEBUG command was received. This command is normally

used only by NBX developers.

Effect. The NBX process is suspended while in debug mode, so applications will not

get any responses to file system requests, and remote sessions may timeout. Note that

the TACL DEBUG command can also be used to place NBX into debug mode, but no

event will be generated in that case.

Recovery. No action is required.

pname Primary process stopping - CPUSWITCH command

pname Domain domain down on subnet subnet

pname Domain domain up on subnet subnet

pname Process entering debug