NetBatch Management Programming Manual

What’s New in This Manual
NetBatch Management Programming Manual—522462-003
xii
New and Changed Information
Changes to the G06.15 Manual
•
Added new event messages to Section 6, Event Messages.
•
Added new NetBatch error codes to Appendix A, Error Numbers and Error Lists.
Previous Changes
The second edition of this manual contained these changes:
New Commands
The D30 programmatic interfaces support these scheduler commands in addition to
scheduler commands supported in the D20 interfaces:
These commands were not available in the D20 interfaces.
Changed Commands
All Commands
Commands previously available only to super-group users are now available to
NetBatch supervisors (users with execute access to the NETBATCH program file).
Class Commands
The variable-length D30 token ZBAT-TKN-SEL-CLASSNAME replaces the fixed length
D20 token ZBAT-TKN-SEL_CLASSNAME in these commands:
Executor Commands
The variable-length D30 Token ZBAT-TKN-SEL-EXECUTORNAME replaces fixed-
length D20 token ZBAT-TKN-SEL-EXECUTORNAME in these commands:
Job Commands
The variable-length D30 token ZBAT-TKN-SEL-JOBNAME replaces the fixed-length
D20 token ZBAT-TKN-SEL-JOBNAME in these commands:
ADD SCHEDULER INFO SCHEDULER STATUS SCHEDULER
ALTER SCHEDULER
ADD CLASS DELETE CLASS INFO CLASS
ALTER CLASS
ADD EXECUTOR INFO EXECUTOR STATUS EXECUTOR
ALTER EXECUTOR START EXECUTOR STOP EXECUTOR
DELETE EXECUTOR
ACTIVATE JOB RELEASE JOB STOP JOB
ALTER JOB RUNNEXT JOB SUBMIT JOB
DELETE JOB RUNNOW JOB SUSPEND JOB
INFO JOB