NetBatch Management Programming Manual

Commands and Responses
NetBatch Management Programming Manual—522462-003
5-24
ALTER JOB Command
ZBAT-TKN-SEL-JOBNAME
specifies a job name or, when specified with either or both the asterisk (*) and
question mark (?) wild-card characters, a range of job names.
ZBAT−TKN−ATT−SET−ID
specifies a value for the job’s ATTACHMENT-SET attribute in the form:
[ ( user-ID ) ] attachment-set-ID
user-ID
specifies the user ID of the attachment-set owner. (user-ID must be in
group-name.user-name or group-ID,user-ID form.) The default is
the user ID of the current user.
attachment-set-ID
is one of:
attachment-set-name
specifies an attachment-set name.
attachment-set-number
specifies an attachment-set number.
ZBAT-TKN-EXECUTOR-PROGRAM
is the name of a program file and specifies the job’s EXECUTOR-PROGRAM
attribute.
ZBAT-TKN-OUT-FILE
is the name of an output file and specifies the job’s OUT attribute.
ZBAT-TKN-VOLUME-SUBVOL
contains the default node, volume, and subvolume used for qualifying unqualified
file references in the job’s input file. The token must specify, at a minimum, a
default volume and subvolume. If the node name is not specified, the scheduler
uses the node of the requester.
Tokens in Response Buffer
For information on the tokens present in the response buffer, see Section 4, Common
Definitions.