NetBatch Management Programming Manual

Commands and Responses
NetBatch Management Programming Manual—522462-003
5-57
STATUS JOB Command
Tokens in Command Buffer
For information on the tokens present in the command buffer, see Section 4, Common
Definitions. Information on the tokens specific to the STATUS JOB command is:
ZBAT-TKN-SEL-JOBNAME
specifies a job name or, when specified with either or both the asterisk (*) and
question mark (?) wild-card characters, a range of job names.
Tokens in Response Buffer
For information on the tokens present in the response buffer, see Section 4, Common
Definitions.
Operational Note
The STATUS JOB command is a nonsensitive command available to all users.
02 ZTIME-USED type ZSPI-DDL-INT4.
02 ZREMID type ZSPI-DDL-BOOLEAN.
02 ZEXECUTOR type ZBAT-DDL-NETBATCH-NAME.
02 ZEXECPHANDLE type ZSPI-DDL-PHANDLE.
02 ZTIME−ELAPSEDMAX type ZSPI−DDL−INT4.
02 ZTIME−CPUMAX type ZSPI−DDL−INT4.
02 ZTIME−ELAPSEDTOTAL type ZSPI−DDL−INT4.
02 ZTIME−CPUTOTAL type ZSPI−DDL−INT4.
02 ZTIME−SUBMIT type ZSPI−DDL−INT4.
02 ZLAST−CC type ZSPI−DDL−INT.
02 ZTIMES−RUN type ZSPI−DDL−INT2.
02 ZTIME−LIMIT type ZSPI−DDL−INT2.
End
ZBAT−TKN−PHANDLE token-type ZSPI−TYP−PHANDLE!{}
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST.
…
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.
ZSPI-TKN-RETCODE token-type ZSPI-TYP-ENUM.!{}
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.
ZSPI-TKN-CONTEXT token-type ZSPI-TYP-BYTESTRING.