NetBatch Management Programming Manual

Commands and Responses
NetBatch Management Programming Manual—522462-003
5-60
STOP EXECUTOR Command
STOP EXECUTOR Command
The STOP EXECUTOR command stops executors whose state is ACTIVE or ON, thus
making them unavailable for use by jobs.
Tokens in Command Buffer
For information on the tokens present in the command buffer, see Section 4, Common
Definitions. Information on the tokens specific to the STOP EXECUTOR command is:
ZBAT-TKN-SEL-EXECUTORNAME
specifies an executor name or, when specified with either or both the asterisk (*)
and question mark (?) wild-card characters, a range of executor names.
Tokens in Response Buffer
For information on the tokens present in the response buffer, see Section 4, Common
Definitions.
Operational Note
The STOP EXECUTOR command is a sensitive command available to NetBatch
supervisors only.
Command
ZBAT-CMD-STOP
Object Type
ZBAT-OBJ-EXECUTOR
Tokens in Command Buffer
ZBAT-TKN-SEL-EXECUTORNAME token-type ZSPI-TYP-STRING.
!{}
ZSPI-TKN-COMMENT token-type ZSPI-TYP-STRING.
ZSPI-TKN-CONTEXT token-type ZSPI-TYP-
BYTESTRING.
Tokens in Response Buffer
ZSPI-TKN-DATALIST token-type ZSPI-TYP-LIST.
ZBAT-TKN-SEL-EXECUTORNAME token-type ZSPI-TYP-STRING.
!{}
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST.
…
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.
ZSPI-TKN-RETCODE token-type ZSPI-TYP-ENUM.!{}
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.
ZSPI-TKN-CONTEXT token-type ZSPI-TYP-
BYTESTRING.