NetBatch Management Programming Manual

Error Numbers and Error Lists
NetBatch Management Programming Manual—522462-003
A-5
517 ZBAT-WRN-JOB-EXECUTING
517 ZBAT-WRN-JOB-EXECUTING
Tokens
ZSPI-TKN-ERROR
is the standard SPI error token. Its value consists of the NetBatch subsystem ID
and the error number ZBAT-WRN-JOB-EXECUTING (517). This token is always
present in the error list.
ZBAT−TKN−NETBATCH−NAME
is the name of the job specified by ZBAT-TKN-SEL-JOBNAME or ZBAT-TKN-SEL-
JOB-NUMBER in the ALTER JOB command.
Cause. An ALTER JOB command operated on an executing, over-limit, or suspended
job.
Effect. The command executed successfully, but only these attributes affect the job:
HOLDAFTER, IFFAILS, PURGE-IN-FILE, RESTART, STALL, and STOP-ON-ABEND.
If the job is recurrent, all altered attributes apply the next time the job runs. (A recurrent
job has the CALENDAR or EVERY attribute.)
Recovery. Informational message only; no corrective action is needed.
518 ZBAT-WRN-WAITON-SATISFIED
Token
ZSPI-TKN-ERROR
is the standard SPI error token. Its value consists of the NetBatch subsystem ID
and the error number ZBAT-WRN-WAITON-SATISFIED (518). This token is always
present in the error list.
Cause. The RELEASE JOB command released an already released dependent job.
Effect. None
Recovery. Not applicable if the command specified the intended job. If not, change
the ZJOBNAME field of ZBAT-MAP-PAR-RELEASE-JOB to specify the intended job
and retry the command.
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZBAT−TKN−NETBATCH−NAME token-type ZBAT−TYP−NETBATCH−NAME
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL