NetBatch Management Programming Manual

Error Numbers and Error Lists
NetBatch Management Programming Manual—522462-003
A-11
529 ZBAT-WRN-E-ACCESS
529 ZBAT-WRN-E-ACCESS
Token
ZSPI-TKN-ERROR
is the standard SPI error token. Its value consists of the NetBatch subsystem ID
and the error number ZBAT-WRN-E-ACCESS (529). This token is always present
in the error list.
Cause. ZBAT-TKN-EXECUTOR-PROGRAM specified a program file secured against
execute access. The job requires execute access to the file to start.
Effect. The command executed successfully, but the job will fail when the scheduler
tries to start it. The scheduler will put the job in the SPECIAL-3 state on failure. (The
STATUS JOB command indicates a SPECIAL-3 state by returning ZBAT-VAL-
NEWPROCESS-ERROR in the ZSPECIAL-REASON field of ZBAT-MAP-STATUS-
JOB.)
Recovery. Ask the owner of the file to resecure it for execute access before the job
starts. Alternatively, use the ALTER JOB command to specify a program file secured
for execute access.
530 ZBAT-WRN-P-ACCESS
Token
ZSPI-TKN-ERROR
is the standard SPI error token. Its value consists of the NetBatch subsystem ID
and the error number ZBAT-WRN-P-ACCESS (530). This token is always present
in the error list.
Cause. The ZPURGE-IN-FILE field of ZBAT-MAP-DEF-JOB set the PURGE-IN-FILE
ON attribute for a job whose input-file security prevents purge access.
Effect. The command executed successfully. However, the scheduler does not purge
the job’s input file when it deletes the job.
Recovery. Not applicable unless you want the scheduler to purge the input file. In that
case, ask the owner of the file to resecure it for purge access before the scheduler
deletes the job.
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL