NetBatch Management Programming Manual

Error Numbers and Error Lists
NetBatch Management Programming Manual—522462-003
A-62
2145 ZBAT-ERR-STARTUP-MESSAGE
2145 ZBAT-ERR-STARTUP-MESSAGE
Tokens
ZSPI-TKN-ERROR
is the standard SPI error token. Its value consists of the NetBatch subsystem ID
and the error number ZBAT-ERR-STARTUP-MESSAGE (2145). This token is
always present in the error list.
ZBAT-TKN-STRING
contains the value specified by ZBAT-TKN-STARTUP-MESSAGE.
Cause. ZBAT-TKN-STARTUP-MESSAGE specified a startup message containing
more than 961 characters or omitted the message altogether.
Effect. The command failed.
Recovery. Change ZBAT-TKN-STARTUP-MESSAGE to specify a valid startup
message containing no more than 961 characters and retry the command.
2146 ZBAT-ERR-STOP-JOB
Token
ZSPI-TKN-ERROR
is the standard SPI error token. Its value consists of the NetBatch subsystem ID
and the error number ZBAT-ERR-STOP-JOB (2146). This token is always present
in the error list.
Cause. The STOP JOB command specified a job whose state was EVENT, READY,
RUNNEXT, RUNNOW, SPECIAL-n, TAPE, or TIME. The command operates only on
executing, over-limit, or suspended jobs.
Effect. The command failed.
Recovery. Use the DELETE JOB command to delete the job. Alternatively, retry the
STOP JOB command, specifying a job whose state is EXECUTING, OVER LIMIT, or
SUSPENDED.
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZBAT−TKN−STRING token-type ZBAT−TYP−STRING
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL