NetBatch Management Programming Manual

Introduction
NetBatch Management Programming Manual—522462-003
1-7
Interactive Commands and Corresponding
Programmatic Commands
These commands (not listed in Table 1-1) are available only in the interactive interface:
This command (not listed in Table 1-1
) is available only in the programmatic interfaces:
ZSPI-CMD-GETVERSION (object type ZSPI-VAL-NULL-OBJECT-TYPE)
STATUS JOB ZBAT-CMD-STATUS ZBAT-OBJ-JOB
STATUS SCHEDULER ZBAT-CMD-STATUS ZBAT-OBJ-SCHEDULER
STOP EXECUTOR ZBAT-CMD-STOP ZBAT-OBJ-EXECUTOR
STOP JOB ZBAT-CMD-STOP ZBAT-OBJ-JOB
SUBMIT JOB ZBAT-CMD-SUBMIT ZBAT-OBJ-JOB
SUSPEND JOB ZBAT-CMD-SUSPEND ZBAT-OBJ-JOB
SWITCHCPU SCHEDULER ZBAT-CMD-SWITCHCPU ZBAT-OBJ-SCHEDULER
SWITCHLOG SCHEDULER ZBAT-CMD-SWITCHLOG ZBAT-OBJ-SCHEDULER
ALLOW ERRORS RELEASE-WAITON
ASSUME object-type RESET object-type
CHANGEUSER RUN
COMMENT SET object-type
DISPLAY-SPI SHOW object-type
EXIT STATUS-HISTORY
FC SYSTEM
HELP VOLUME
HISTORY !
OBEY ==
OPEN ?
Table 1-1. Interactive Commands and Corresponding Programmatic
Commands (page 2 of 2)
Interactive Command Programmatic Command Object Type