NetBatch Management Programming Manual

Error Numbers and Error Lists
NetBatch Management Programming Manual—522462-003
A-84
2198 ZBAT-ERR-WILDCARD
2198 ZBAT-ERR-WILDCARD
Token
ZSPI-TKN-ERROR
is the standard SPI error token. Its value consists of the NetBatch subsystem ID
and the error number ZBAT-ERR-WILDCARD (2198). This token is always present
in the error list.
Cause. The RUNNEXT JOB or RUNNOW JOB command used wild-card characters
to specify a range of job names. These commands do not support wild-card character
searching in your version of the NetBatch product.
Effect. The command failed.
Recovery. Change ZBAT-TKN-SEL-JOBNAME or ZBAT−TKN−SEL−JOB−NUMBER
to specify the full name or number of a single job and retry the command.
2199 ZBAT-ERR-JOB-TOO-MANY-ATT
Token
ZSPI-TKN-ERROR
is the standard SPI error token. Its value consists of the NetBatch subsystem ID
and the error number ZBAT-ERR-JOB-TOO-MANY-ATT (2199). This token is
always present in the error list.
Cause. The command specified more than three attachment sets for the job. Your
NetBatch scheduler allows only three attachment sets per job.
Effect. The command failed.
Recovery. Specify no more than three attachment sets for the job and retry the
command.
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL