NetBatch Management Programming Manual

NetBatch Management Programming Manual—522462-003
2-1
2
Communicating With the NetBatch
Subsystem
This section explains how to set up communication between a management
application and the NetBatch subsystem:
Steps in Communicating With the NetBatch
Subsystem
Figure 2-1 summarizes the procedure your application must follow when
communicating with the NetBatch subsystem.
For descriptions of Steps 1 and 4, see Opening a Scheduler on page 2-3 and Closing a
Scheduler on page 2-5, respectively.
For descriptions of Steps 2 and 3, see Building and Sending a Command Message on
page 3-5 and Receiving and Decoding a Response Message on page 3-7,
respectively.
Topic Page
Steps in Communicating With the NetBatch Subsystem
2-1
Starting a Scheduler 2-2
Opening a Scheduler 2-3
Closing a Scheduler 2-5
Stopping a Scheduler 2-6
Running an EMS Consumer Distributor 2-6