NetBatch Manual

Commands
NetBatch Manual—522460-004
6-110
INFO SCHEDULER Command
INFO SCHEDULER Command
Use the INFO SCHEDULER command to list the attributes of schedulers.
file-name
specifies a command output file. The file can be a device, a process, or a disk file.
For a disk file, BATCHCOM appends output if the file exists, but creates an EDIT
file if the file does not exist. If you specify / OUT / (that is, omit file-name),
BATCHCOM suppresses output.
attribute
is one of these scheduler attributes:
attribute causes BATCHCOM to list only the specified attribute. If you omit
attribute, BATCHCOM lists all attributes.
OBEY-FORM
causes BATCHCOM to list attributes in ALTER SCHEDULER command format.
BATCHCOM prefixes the ALTER commands with the ASSUME SCHEDULER and
RESET SCHEDULER commands.
Considerations
•
The INFO SCHEDULER command is available to all users.
•
The OBEY-FORM qualifier is available for all INFO commands. It enables the
creation of BATCHCOM command files that you can use to set up a scheduler. For
more information, see Section 3, Scheduler Planning, Configuration, and
Management.
I[NFO] [ SCHEDULER ] [ / OU[T] [ file-name ] / ]
[ , attribute ]… [ , O[BEY]-[FORM] ]
AT-A[LLOWED] D[EFAULT]-
MAXPRINTP[AGES]
INI[TIATION]
B[ACKUPCPU] D[EFAULT]-O[UT] LO[CALNAMES]
CAT[CHUP] D[EFAULT]-P[RI] M[AX]-[CONCURRENT]-
[JOBS]
D[EFAULT]-C[LASS] D[EFAULT]-SE[LPRI] M[AX]-[PRI]
D[EFAULT]-E[XECUTOR]-
[PROGRAM]
D[EFAULT]-ST[ALL] S[UBMIT]-A[LLOWED]
D[EFAULT]-H[IGHPIN] D[EFAULT]-[STOP]-
[ON]-[ABEND]
TA[PEDRIVES]
D[EFAULT]-
MAXPRINTL[INES]
EM[S]